How To Exclude Surfaces From Shell Definition Ptc Creo Ptc Creo Tips In this tech tip, we will explain about advanced options in ‘shell’ feature. we will see in detail how to exclude some unwanted surfaces from the definition of ‘shell’ feature. To exclude surfaces from being shelled, click the options tab, and click the exclude surfaces collector, and select one or more surfaces to exclude from the shell.
How To Exclude Surfaces From Shell Definition Ptc Creo 6001 Cass Avenue Suite 600 The original model is shown in the following illustration. 1. on the references tab, click the remove surfaces collector. 2. select the top surface as the surface to remove. 3. to exclude surfaces from the shell process, on the options tab, click the exclude surfaces collector. 4. select the surfaces to exclude in the graphics window. 1. 5. We will see in detail how to exclude some unwanted surfaces from the definit. To remove surfaces, on the references tab, click the remove surfaces collector, and select one or more surfaces. you can also select the surfaces to remove before you enter the shell tool. If the stated goal was to use a master sketch with a shell and minimize feature count, i would propose this as a method which captures the dimensioning scheme useful to produce the drawing.
How To Exclude Surfaces From Shell Definition Ptc Creo 6001 Cass Avenue Suite 600 To remove surfaces, on the references tab, click the remove surfaces collector, and select one or more surfaces. you can also select the surfaces to remove before you enter the shell tool. If the stated goal was to use a master sketch with a shell and minimize feature count, i would propose this as a method which captures the dimensioning scheme useful to produce the drawing. We will see in detail how to exclude some unwanted surfaces from the definition of ‘shell’ feature. in following figure, a shell type feature is created and the bottom surface of the flange is selected as ‘removed surface’. At the tangent edge, where the separation of the shell offset occurs, a normal capping surface is constructed to close the gap. you can also exclude one or more surfaces from being shelled by specifying the surfaces in the exclude surfaces collector. this process is called partial shelling. Press ctrl and select one or more highlighted surfaces that you want to exclude from perform a modeling action. creo parametric constructs the excluded surface set and adds the excluded surfaces to it. You must select the surfaces you want to remove from the model, and you must specify the thickness of the remaining model walls to create a shell feature. you can select multiple surfaces to remove from the model. you can also choose the non default thickness for your shell feature.
Comments are closed.